AEG HG654320UM Manual do Utilizador

HG654320UMGB IE ENGAS HOB USER MANUAL

fied electrician (e.g. your local Electricity Board, or a contractor who is on the roll of theNational Inspection Council for Electrical Installation

The replacement of the electrical cable must be done by a qualified electrician or compe-tent person, according to the current regulations.Replacement

Kitchen unit with ovenThe hob recess dimensions must obey the indication and the kitchen unit must be equippedwith vents to let a continuous supply of

OPERATIONIgnition of the burnerWARNING!Be very careful when you use open fire in kitchen environment. Manufacturer decline anyresponsibility in case m

If the burner accidentally goes out, turn the control knob to the off position and try to lightthe burner again after minimum 1 minute.The spark gener

WARNING!Make sure pot handles do not protrude over the front edge of the cooktop and that potsare centrally positioned on the rings in order to achiev

• Be very careful when you replace the pan supports to prevent the hob top fromdamage.After cleaning, dry the appliance with a soft cloth.Removing the

Problem Possible cause RemedyThe flame is blow out immedi-ately after ignition• Thermocouple is not heatedsufficient• After lightning the flame,keep t

TECHNICAL DATAHob dimensionsWidth: 595 mmLength: 525 mmHob recess dimensionsWidth: 560 mmLength: 480 mmHeat inputRapid burner: 2.9 kWSemi-rapid burner

BURNERNORMALPOWERREDUCEDPOWERNORMAL POWERNATURAL GASG20 (2H) 20 mbarLPG(Butane/Propane) G30/G31 (3+)28-30/37 mbarkW kWinj. 1/100mmm³/hinj. 1/100mmG302

FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn

www.aeg.com/shop 397249401-A-392011

CONTENTS4 Safety information7 Installation12 Product description13 Operation14 Helpful hints and tips15 Care and cleaning16 What to do if…18 Technical

SAFETY INFORMATIONWARNING!These instructions are only valid in the countries whose symbols appear on this booklet'scover.For your safety and cor

• The cookware must not enter the control zone.• Make sure that the cookware does not protrude over the edges of the cooking surfaceand that it is cen

• Before installation, make sure that the local supply conditions (gas type and pressure)agree with the adjustment of appliance. The adjustment condit

INSTALLATIONWARNING!The following instructions about installation, connection and maintenance must be carriedout by qualified personnel in compliance

1231End of shaft with nut2Washer3ElbowConnection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or cop-per.The connectio

1. Light the burner.2. Turn the knob on the minimum position.3. Remove the knob.4. With a thin screwdriver, adjust the by-pass screw position.11 The