AEG 11126GR-MN Manual do Utilizador descarregar pdf (Página 27)

C

3. Carefully move the burner off the

injector support D.

D

E

F

4. Slowly move it to the left side. Make

sure that the burner bush stays on

the burner mouthpiece. Do not apply

force to the wire of the spark plug

connector F and to the

thermocouple conductor E.

5. Release the burner injector D with a 7

mm socket spanner and replace it

with a different one.

Assemble the burner in a revers

sequence.

Replace the gas type sticker near the gas

supply ramp with the one related to the

new gas type.

14.14 Adjusting the minimum

gas level on the oven burner

1. Disconnect the appliance from the

electricity.

2. Remove the knob for the oven

functions. If there is no access to the

bypass screw dismount the control

panel before adjustment start.

3. With a thin and flat screwdriver adjust

the bypass screw A.

The model determines the position

of the bypass screw A.

A

Changing from natural gas to

liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

3. Connect the appliance to the

electricity.

Changing from liquid gas to

natural gas

1. Unscrew approximately one turn the

bypass screw position A.

2. Put the knob for the oven functions

back.

3. Connect the appliance to the

electricity.

WARNING!

Put the mains plug into

the mains socket only if

all parts are back into

their initial position.

There is a risk of injury.

4. Light the burner.

Refer to "Oven - Daily use" chapter.

5. Turn the knob for the oven functions

on the minimum position.

6. Remove the knob for the oven

functions again.

ENGLISH

27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Comentários a estes Manuais

Sem comentários