AEG KFA58SIO Manual do Utilizador descarregar pdf (Página 14)

Problem Possible cause Remedy

comes on.

There is an error in the hob

because a cookware boils

dry. Automatic Switch Off

and the overheating protec-

tion for the zones operate.

Deactivate the hob. Remove

the hot cookware. After ap-

proximately 30 seconds, acti-

vate the zone again. If the

cookware was the problem,

the error message goes out.

Residual heat indicator can

stay on. Let the cookware

become sufficiently cool.

Check if your cookware is

compatible with the hob.

Refer to “Hints and tips”

chapter.

7.2 If you cannot find a

solution...

If you cannot find a solution to the

problem yourself, contact your dealer or

an Authorised Service Centre. Give the

data from the rating plate. Give also

three digit letter code for the glass

ceramic (it is in the corner of the glass

surface) and an error message that

comes on. Make sure, you operated the

hob correctly. If not the servicing by a

service technician or dealer will not be

free of charge, also during the warranty

period. The instructions about the

Service Centre and conditions of

guarantee are in the guarantee booklet.

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down

the information bellow from the rating

plate. The rating plate is on the bottom

of the hob.

Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you

assemble the hob into correct built-in

units and work surfaces that align to the

standards.

During installation in combustible

matter, NIN SEV 1000 and fire protection

guidelines and regulations of the

Association of Cantonal Fire Insurance

shall be strictly adhered to.

8.3 Connection cable

• The hob is supplied with a connection

cable.

• To replace the damaged mains cable

use the following (or higher) mains

cable type: H05VV-F. Speak to your

local Service Centre.

8.4 Electrical connection

Install the hob with a socket supply line.

If there is no socket supply line, the fixed

home electrical system must include an

isolating device with at least a 3 mm-

contact separation to enable a

simultaneous and all-pole cut off from

the mains (according to NIN SEV 1000).

8.5 Attaching the seal to the

rabbet

1. Clean the rabbets in the worktop.

2. Cut the supplied seal stripe into 4

stripes. The stripes must have the

same length as the rabbets.

www.aeg.com

14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários