AEG BOBM Manual do Utilizador descarregar pdf (Página 23)

5. Put the door with the outer side

down on a soft cloth on a stable

surface. This is to prevent scratches.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them

up out of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, install

the glass panels and the door. Do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger.

9.5 Replacing the lamp

Put a cloth on the bottom of the interior

of the appliance. It prevents damage to

the lamp glass cover and the cavity.

WARNING!

Danger of electrocution!

Disconnect the fuse before

you replace the lamp.

The lamp and the lamp glass

cover can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box

or deactivate the circuit breaker.

The top lamp

1. Turn the lamp glass cover

counterclockwise to remove it.

2. Clean the glass cover.

3. Replace the lamp with a halogen, 230

V, 40 W, 300 °C heat resistant lamp.

4. Install the glass cover.

10.

TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

10.1 What to do if...

Problem Possible cause Remedy

The oven does not heat up. The oven is deactivated. Activate the oven.

The oven does not heat up. The fuse is blown. Make sure that the fuse is

the cause of the malfunction.

If the fuse is blown again

and again, contact a quali-

fied electrician.

ENGLISH 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Comentários a estes Manuais

Sem comentários

AEG BOBM Manual do Utilizador Página 23

Comentários a estes Manuais

Manuais e produtos relacionados com não AEG BOBM