AEG AG78850I Manual do Utilizador descarregar pdf (Página 11)

Defrosting

The freezer will become progressively covered with frost. This should be

removed with the special plastic scraper provided, whenever the thickness

of the frost exceeds 4 mm. During this operation it is not necessary to swit-

ch off the power supply or to remove the foodstuffs.

However when the ice becomes very thick on the inner liner, complete

defrosting should be carried out as follows:

1. Remove the frozen food from the

freezer, wrap it in several layers of

newspaper and put it in a very

cool place.

2. Switch off the appliance and pull

out the plug, or turn the tempe-

rature regulator to “0”.

3. Leave the freezer compartment

door open.

4. Insert the plastic scraper into the

recess provided under the defrost

water channel and place a collec-

ting basin under it.

5. Once defrosting is completed keep the scraper for future use;

6. Turn the thermostat control knob to the required setting or replace the plug

in the power socket.

Warning!

Never use metal tools to scrape off the frost

Do not use a mechanical device or any artificial means to speed up the

thawing process other than those recommended by the manufacturer.

A temperature rise of the frozen food packs, during defrosting , may shor-

ten their safe storage life.

If, after carrying out the necessary checks there is still a fault with your

appliance please contact your local AEG Service Force Centre.

In guarantee customers should ensure that the suggested checks have

been made as the engineer will make a charge if the fault is not a mecha-

nical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service

calls.

Heavy build up of frost, possi-

bly also on the door seal.

Door seal is not air tight (pos-

sibly after reversing the door).

Carefully warm the leaking

sections of the door seal with

a hair dryer (not hotter than

approx. 50 °C). At the same

time shape the warmed door

seal by hand until it sits cor-

rectly.

The food is too warm.

The appliance is near a heat

source.

Temperature is not properly

adjusted.

Please look in the "Initial Start

Up" section.

Turn the temperature control

knob to a colder setting.

Door was open for an exten-

ded period.

Please look in the "Installation

location" section.

A large quantity of warm

food was placed in the

appliance within the last 24

hours.

Open the door only as long as

necessary.

Symptom Possible Cause Remedy

Appliance does not work.

Appliance is not switched on Switch on the appliance.

Mains plug is not plugged in

or is loose.

Insert mains plug.

Fuse has blown or is defective.

Check fuse, replace if neces-

sary.

Socket is defective.

Mains malfunctions are to be

corrected by an electrician.

Appliance cools too much. Temperature is set too cold.

Turn the temperature control

knob to a warmer setting.

The compressor starts after a

period of time.

This is normal, no error has

occurred.

The compressor does not start

immediately after changing

the temperature setting.

1 2 ... 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

AEG AG78850I Manual do Utilizador Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com não AEG AG78850I