AEG KVH 32 Guia de Instalação descarregar pdf (Página 44)

43

i. Add the new receivers to the Autoswitch

page of the web interface. Enter each

receiver’s static IP address and assign it a

friendly name (e.g., “Salon”) (see Figure 71).

Figure 71: Adding a DIRECTV Receiver to the Autoswitch Page

Also be sure to set each receiver’s Dish Type

to 3-LNB and Switch Type to SWM, and

enable external device access, as directed by

the TV-Hub’s Setup Wizard. If the TV-Hub is

then unable to communicate with the

receiver, try resetting the receiver (press its

red reset button or unplug it, wait 15 seconds,

then plug it back in and turn it on).

IMPORTANT!

Continued Using a DIRECTV Coax Network

B

1 2 ... 39 40 41 42 43 44 45 46

Comentários a estes Manuais

Sem comentários