
Problem Possible cause Remedy
There is water or fat
stains on the control
panel.
Clean the control panel.
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
You put something on
one or more sensor
fields.
Remove the object from
the sensor fields.
The appliance deacti-
vates.
You put something on
the sensor field
.
Remove the object from
the sensor field.
The residual heat indica-
tor does not comes on.
The cooking zone is not
hot because it operated
only for a short time.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the
service centre.
You cannot activate the
outer ring.
Activate the inner ring
first.
The sensor fields be-
come hot.
The cookware is too
large or you put it too
near to the controls.
Put large cookware on
the rear cooking zones if
necessary.
comes on.
The Automatic Switch
Off operates.
Deactivate the appliance
and activate it again.
comes on.
The Child Safety Device
function operates.
Refer to the chapter
“Daily Use”.
and number comes
on.
There is an error in the
appliance.
Disconnect the appli-
ance from the electrical
supply for some time.
Disconnect the fuse from
the electrical system of
the house. Connect it
again. If
comes on
again, speak to the serv-
ice centre.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.
8. INSTALLATION
WARNING!
Refer to the Safety chapters.
Before the installation
10
www.aeg.com
Comentários a estes Manuais