AEG HG755440SM Manual do Utilizador descarregar pdf (Página 12)

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the

by-pass screw position.

A

A)

The by-pass screw

• If you change from natural gas G20/

G25 20/25 mbar to liquid gas, fully

tighten the by-pass screw in.

• If you change from liquid gas to natu-

ral gas G20/G25 20/25 mbar, undo the

by-pass screw approximately 1/4 of a

turn (1/2 of a turn for Triple Crown

burner).

• If you change from natural gas G20/

G25 20/25 mbar to town gas G130 8

mbar unscrew approximately 3/4 of a

turn (1/4 of a turn for Triple Crown

burner).

• If you change from town gas G130 8

mbar to natural gas G20/G25 20/25

mbar screw approximately 3/4 of a

turn (1/4 of a turn for Triple Crown

burner).

• If you change from liquid gas to town

gas G130 8 mbar unscrew approxi-

mately 1 turn (1/2 of a turn for Triple

Crown burner).

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.4 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate

agree with the voltage and the power

of the local power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a cor-

rect plug which can hold the load that

the rating plate rates. Make sure that

you install the plug in a correct socket.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• There is a risk of fire when the appli-

ance is in connection with an exten-

sion cable, an adapter or a multiple

connection. Make sure that the

ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

Make sure that you connect the blue

neutral cable to the terminal with a letter

"N" on it. Connect the brown (or black)

phase cable to the terminal which has a

letter "L". Keep the phase cable connec-

ted at all times.

8.5 Replacement of the

connection cable

To replace the connection cable use on-

ly H05V2V2-F T90 or equivalent type.

Make sure that the cable section is appli-

cable to the voltage and the working

temperature. The yellow/green earth

wire must be approximately 2 cm longer

than the brown (or black) phase wire.

8.6 Building In

min.

55 mm

min.

650 mm

560 mm

480 mm

min.

150 mm

30 mm

12

www.aeg.com

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários