AEG C88000M Manual de Serviço descarregar pdf (Página 17)

- 17 -

TSE-N 05.00 A. B. 599 50 82 27 EN

Safety instructions for the installer

- This hob must be installed by qualified personnel, according to the manufacturers instructions and

to the relevant country standards.

- In respect of fire protection, this appliance corresponds to type Y (IEC 335-2-6). Only this type of

appliance may be installed with a high cupboard or wall on one side.

- It is not permitted to fit drawers below the cooking surface.

- Protection against electric shock must be provided by the installation.

- The kitchen unit in which the appliance is fitted must satisfy the requirements of DIN 68930 in

respect of stability.

- Built-in ovens and cooking surfaces are fitted with special connector systems. They may only be

combined with appliances with a matching system.

- All cut surfaces are to be sealed with a suitable sealant for protection against moisture.

- On tiled work surfaces, the joints in the area where the hob sits on the surface must be completely

filled with grout.

- On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place.

- Ensure that the seal is correctly seated in the frame and that it is sea-ted against the work surface

without leaving any gaps. Additional silicon sealant must not be applied, this will make removal

more difficult in the event of the need for service.

- To remove the hob, it must be pressed out from below.

Electrical connection

- Connect the wiring harness plugs with the respective sockets of the same colour of the built-in

oven or switch box.

C67600M and C88000M

This induction glass ceramic cooking zone can only be combined with the following AEG units:

Competence E 8. . .

Competence E 6. . .

Competence E 4106-1

Competence S 8. . .

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Sem comentários

AEG C88000M Manual de Serviço Página 17