AEG AW8550TFGVTC Manual do Utilizador descarregar pdf (Página 10)

11 11

Oven burner mod. G5

To change the oven injector, it is necessary to act as follows: open

the over door, remove the lower side (see fig. C).Unsrew screws

4 (fig. G1) presents on the final part of the oven burner .

Change the injector 3 and replace it with another one suitable for

the new gas type (see tab. D1). Re-assemble everything in the

opposite direction.

Grill burner mod. G5

To change the grill injector, it is necessary to act as follows: remove

the screw A (see fig. G2).Remove burner from its location.

Change the injector (fig.G3) and replace it with another one suitable

for the new gas type (see tab. D1). Re-assemble everything in

the opposite direction.

MINIMUM FLOW ADJUSTMENT FOR OVEN THERMOSTAT

In order to adjust the minimum, act as follows: switch the burner

on turning the knob to the maximum position.

Remove the knob and unscrew of some turns the by-pass screw

(fig. H).

Assemble the knob and let the oven warm up for 15 minutes; after

that turn the knob to the minimum position.

After having removed the knob once again, making sure that the

thermostat rod has not been moved, screw slightly the above

mentioned by-pass screw, to obtain a flame of 3 or 4 mm of length.

For butane/propane gas, the adjusting screw must be tight screwed.

Make sure that the flame does not extinguish passing quickly from

the maximum flow to the minimum flow, and closing and opening

the oven door (the oven door must be closed softly).

Attention: for taps with safety device, the minimum adjusting screw

“T” is on the outside of the tap rod (fig. I ).

Fig. H

Fig. I

Fig. 11

Fig. 12

Unscrew the adjusting screw in order to increase the flow or screw

it to decrease the flow.

The right adjustment is obtained when the flame has a length of

about 3 or 4 mm.

For butane/propane gas, the adjusting screw must be tight screwed.

Make sure that the flame does not go out passing quickly from

the max. flow to the minimum flow and viceversa .

Assemble the knob again.

MINIMUM FLOW ADJUSTMENT FOR WORK-TOP TAPS

In order to adjust the minimum, act as follows: switch the burner

on, and turn the knob towards the minimum flow position .

Remove the knob from the tap, introduce a little screwdriver in the

tap rod (fig. 11).

Attention: in taps with security valve, the minimum adjusting screw

“Z” is placed outside the rod tap (fig. 12).

FIG.G2

D 1

FIG.G3

FIG.G2

FIG.G1

TAB. D1 GENERAL INJECTORS TABLE

Kind of gas mbar Nozzle Burners Power Watt Consum.

mm Position-type max. min. max

0,85 Oven Ter. 3300 1200 241 g/h

0,75 Grill Ter. 2400 175 g/h

Oven no thermostat

0,80 Oven Ter. 3000 1200 219 g/h

L.P.G. 30

(25-35)

G5.

Ter.

1 2 ... 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

AEG AW8550TFGVTC Manual do Utilizador Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões AEG AW8550TFGVTC