AEG 6530K-MNAC1 Manual do Utilizador descarregar pdf (Página 29)

Installing and connecting up

Installing

Important: Assembly and connection of the new appliance may only

be performed by an approved installer.

Please observe this instruction, otherwise the warranty will not cover

any damage that may occur.

The veneer or plastic coverings on kitchen furniture around the appli-

ance must be bonded with heat resistant adhesive (100 °C). If plastic

coverings or the adhesive are not sufficiently temperature resistant,

then the covering may distort or come loose.

In respect of fire protection, the appliance corresponds to type Y

(EN 60335-2-6). Only this type of appliance may built into positions

with a high cupboard or wall on one side.

The cooking surface must have a heat protective base permanently

fixed in position. The distance from the base to the underside of the

cooking surface must be at least 50 mm. The edges of the cut out must

be coated with a water proof material. The cooking surface must be

built-in such that the TOUCH CONTROL control panel is at the front

(see fig.).

The separation between the hob and the extractor hood must be at least

as large as that given in the extractor hood installation instructions.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35

Sem comentários

AEG 6530K-MNAC1 Manual do Utilizador Página 29