Aeg COMPACT READER ARE I2 Manual do Utilizador descarregar pdf (Página 26)

Manual

Page 26 / 33- Revision 01

ARE I2 / RS 232 – Installation Guide

AEG

Identifikationssysteme GmbH

Söflinger Straße 100

D-89077 Ulm

Tel. ++49(0)731-933-1340/1877

Fax ++49(0)731-933-1855

7.2 Operating Mode 0 - Continuous Reading

When operating continuously the exciter is switched on permanently. The reading cycles

are initiated periodically.

After an accomplished reading cycle the reading information is evaluated. After that data (ei-

ther transponder number or NoRead code) is output to the serial interface

Figure 7.2: continuous operation

7.2.1 Settings of the Reader / Most Used Parameters

The default operation mode is changed by sending a software command to the reader.

In combination with an R / W transponder, the serial number of the transponder device is read

out only.

MD 0 - continuos read

most used parameters.

• CID 0 - no suppression of repeatedly read Ids

• CN 0 - no suppression of NoReads

exciter

processor

interface

reading cycle

ID ID ID

reading cycle reading cycle

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33

Sem comentários

Aeg COMPACT READER ARE I2 Manual do Utilizador Página 26